找回密码
 注册

QQ登录

只需一步,快速开始

查看: 33011|回复: 36

2013领的新版BCM6828 RG200O-CA 光猫完全拆解展示

[复制链接]
发表于 2013-1-17 23:43:39 | 显示全部楼层 |阅读模式
本帖最后由 yehaku 于 2013-1-17 16:29 编辑

内部芯片
无线:BCM43217KMLG
VOIP芯片:LE9530CETC
内存:NANYA NT5TU32M16DG-AC 128MB
FLASH:NAND256W3A2BN6E 256M SLC
http://www.micron.com/parts/nand ... bn6e#orderableParts
CPU:BCM6828FKFBG 没查到资料不知道是多少主频的。






无线部分:BCM43217KMLG 采用内部双天线隔了1墙的笔记本信号只掉1格感觉还不错。
外部天线是装饰。不过可以自己加。加了就是3天线了。


内存:NANYA NT5TU32M16DG-AC 64X16=1024bit=128MB DDR2 内存基本来说够用了。



拆开散热器的 CPU:BCM6828FKFBG 不知道哪里能查到资料
不过BCM的方案网络稳定性还是比较好的。而且估计以后会像BCM6358猫那样出现不少第三方功能强大的固件。



EPON 光模


供电部分做工



交换模块和主板版本号。其中第4的LAN口为1G接口。



TTL 和JATG接口








本帖子中包含更多资源

您需要 登录 才可以下载或查看,没有账号?注册

×
发表于 2013-12-12 23:36:39 | 显示全部楼层
这个要顶 2013新款RG2000-CA
 楼主| 发表于 2013-1-18 06:51:47 | 显示全部楼层
补充下BUG内存应该是64MB。不小心吧换算公式记错了。应该是 32X16/8=64MB
FLASH 换算回计算机上的MB来也是32MB的
 楼主| 发表于 2013-1-18 08:15:32 | 显示全部楼层
继续补充 CPU:BCM6828FKFBG 国外论坛看了下听说是500-600MHZ 双核心网络处理器。
是BCM6818 的升级版。估计是提高了频率的版本就不知道稳定夏天到了怎么样。反正冬天进WEB看
CPU温度监控显示的是35度。比老版采用6818 的中兴F460好像要高点。

    Broadcom's high performance, 500-600 MHz dual core processor architecture
    Hardware-assisted gigabit bridging and routing
    Hardware-assisted IPsec security for virtual private network (VPN) termination
    Gigabit switch and physical layer (PHY) devices
    Voice over Internet Protocol (VoIP)
    Support for USB 2.0 host and devices
    Support for Broadcom's latest WLAN devices utilizing PCI Express®
 楼主| 发表于 2013-1-18 08:19:24 | 显示全部楼层
无线:BCM43217KMLG

    Broadcom's first IEEE 802.11n draft-compliant Wi-Fi® reference design for PCI Express notebook design solutions
    Two spatially multiplexed streams support data rates up to 270 Mbps
    Compatible with installed base of 802.11a/b/g devices
    Leverages Broadcom's proven OneDriver™ software to deliver superior performance, ease-of-use and security features, including SecureEasySetup™
 楼主| 发表于 2013-1-18 08:23:09 | 显示全部楼层
VOIP:LE9530CETC
The Le9530 Dual Ringing SLIC device is a dual-channel device optimized to provide battery feed, ringing, and supervision on voice loops found in short-loop VoIP applications. This device is optimized to interface to the Broadcom BCM3378/3380/3382 and BCM6816 devices, or a similar codec. The Le9530 device operates independently from a single, user-adjusted battery and a +3.3 V VCC per channel. Each channel provides forward and reverse battery feed, voice transmission, power ringing, an ultra low-power scan state, ground start (Tip open), and a disconnect state. A test load switch is also included to support integrated test algorithms.

Features & Benefits

    Dual Architecture
        Two fully independent integrated SLIC channel
        No impulse noise crosstalk in any operation states to the listening channel in forward or reverse active states
    Two Power Supplies
        Single user adjusted battery input per channel
        3.3 V for VCC
    High Voltage Design
        Meets Comcast Ringing requirements without clipping
        distortion
        Robust solution with no damage during extended ringing cycles or switching the ringer on and off
        Allows use of 50 ? protection resistors and lower cost lower current rated protectors
        Two Grades
            Up to ?145 V ringing battery Le9530D
            Up to ?100 V ringing battery Le9530C
    Channel Independent Eight Operating States
        Scan state for minimal power dissipation
        Active Forward Battery 25mA DC Current Limit
        Active Reverse Battery 25mA DC Current Limit
        Active Forward Battery 40mA DC Current Limit
        Active Reverse Battery 40mA DC Current Limit
        Tip Open Ground Start
        Ringing
        Disconnect (Default Power Up Mode)
    Per Channel Ringing Inputs for Optimized Interface to BCM SoC Devcies
        Allows to accept driving signals from per channel voice outputs as well as from PWM outputs
    Ultra-Low On-Hook Power
    Loop Start, Ring Trip, and Ground Start Detections
        Loop closure detection with hysteresis to minimize dial pulse distortion
    Thermal Shutdown Protection with Hysteresis
    Test Load Switch
    Supports integrated test algorithms
发表于 2013-1-18 09:11:36 | 显示全部楼层
还有别的光猫图片吗
发表于 2013-1-18 09:11:49 | 显示全部楼层
很好很详细,这个要支持。
 楼主| 发表于 2013-1-18 09:32:18 | 显示全部楼层
永远的疯子 发表于 2013-1-18 01:11
还有别的光猫图片吗

目前只有这个。本来是选新版中兴F460的。不过师傅拿来对比穿墙无线信号。笔记本上掉了2格。这个也就只掉1格。然后这个CPU稍微要比中兴的强点。双核心500-600 MHZ。另外就是无线部分也是用的BCM 270MHZ的芯片。手机连接上比螃蟹芯片要稳定不少。而且考虑到全BCM芯片的方案后期国外的无限制固件好刷些。
发表于 2013-1-18 09:52:10 | 显示全部楼层
你那有没F460固件呢
 楼主| 发表于 2013-1-18 10:00:28 | 显示全部楼层
另外提供个第3方GEPON 固件 的下载地址 大家一起研究。准备校对好了。刷采用BCM6228 支持H248VOIP方案的无限制FW。彻底摆脱电信控制
http://ftp.dlink.ru/pub/GEPON/
*滑块验证:
您需要登录后才可以回帖 登录 | 注册

本版积分规则

Archiver|小黑屋|宽带技术网 |网站地图 粤公网安备44152102000001号

GMT+8, 2025-7-2 04:11 , Processed in 0.036658 second(s), 5 queries , Redis On.

Powered by Discuz! X3.5 Licensed

Copyright © 2001-2020, Tencent Cloud.

快速回复 返回顶部 返回列表