|
发表于 2009-9-11 06:16:23
|
显示全部楼层
本帖最后由 dong342819 于 2009-9-10 22:20 编辑
Diagnostics
Expand All
Collapse All
System
Product Name = SpeedTouch 510
Vendor Name = THOMSON
Software Version = 4.2.7.16.0
Serial Number = 85B13N5
CLI Version = 1.2.0
Bootloader Version = Not retrievable
ASIC Version = 1b01
Board Name = ADNT-Q
Modem Label Version = 2.11.36
Lan
Ethernet
Interface name = eth0
Physical address =
Physical Interface
Mode = forwarding
Auto Negotiation = Yes
Type = 100BaseTFD
kBytes Tx/Rx = 48422 / 3008
Frames Tx/Rx = 38725 / 25815
Discarded frames = 2
Wan
Dsl
DSL Flavour = ADSL over POTS
Reserved Bandwidth (kbit/s) up/down = 640 / 3072
Uptime = 00:18:24
kBytes Tx/Rx = 4180 / 55176
Properties
Output Power (dBm) up/down = 12.0 / 19.0
Attenuation (dB) up/down = 11.0 / 18.0
Noise Margin (dB) up/down = 16.0 / 31.0
Vendor Id (local/remote) = ALCB / GSPN
Statistics
Loss of signal (local/remote) = 0 / 0
Loss of power (local/remote) = 0 / 0
Loss of framing (local/remote) = 0 / 0
Errored Seconds (local/remote) = 0 / 1
Loss of link (remote) = 0
Connections
PPPoE_1
Connection Type = PPPoE
kBytes Tx/Rx = 2325 / 47149
Username = ****
Password = ****
Access Concentrator =
Service Name =
Last Connection Error = None
Uptime = 00:18:20
IP Connectivity
Ping Address = 202.101.224.69
Ping Address Description = Primary DNS server (specified by IPCP)
Ping Roundtrip Time (in msec) = 37
Ping Packetsize (in bytes) = 20
IP
Local IP Address = 59.55.61.12
Remote IP Address = 59.55.60.1
Other IP Addresses = Not Configured
Primary DNS = 202.101.224.69
Secondary DNS = 202.101.226.68
MTU Size = 1492
Address Translation = pat
UnicastPackets Tx/Rx = 24312 / 36545
BroadcastPackets Tx/Rx = 0 / 0
Packets Dropped = 0
PPP
Username =
Password = ********
MRU Size = 1492
Admin. State = up
Oper. State = up
Link State = connected
LCP State = opened
IPCP State = opened
Retry interval = 10
PPPoE
Service Name = jxcard
Access Concentrator =
RELAY
Interface Admin. State = Up
PPPoE relay session id = 1 (client)
Relay portlist
format: ETH Intf (Status) [-> Phonebook Name(Address,QoS [,autoconfigured])]
1. ETHoA_1 (up) -> PVC_1 (0.35, ubr)
2. eth0 (up)
Ethernet
Interface Name = ETHoA_1
Interface Type = ETHoA
Interface Admin. State = connected
ATM
Phonebook Name = PVC_1
Address = 0.35
Encapsulation = llc/snap
Auto Configured = no
QoSbook Name = default
QoS Type = ubr |
|