关于conexant芯片ADSL路由器的上网设置问题

Sharv

zyr486

http://auction1.taobao.com/auction/11-1108/item_detail-0db2-a9f69156c563259c11d7fad58e0e8507.jhtml
这里有详细解说

Sharv

我就是在这家买的，介绍和实际有些不符，所以到现在还没有上去网。

wbh1414

我告诉你吧。你把虚电路0关了， 进广域网，更换虚电路1，在调试一下吧，一定行的，我手里面好几个猫都是这么设置的！！！

wildman

。。

Sharv

01/01/1970 00:00:00> Ethernet Device 0 Detected
01/01/1970 00:00:00> ATM: Detected
01/01/1970 00:00:00> ATM: Setting up vcc0, VPI=8, VCI=35
01/01/1970 00:00:00> Initialized Dynamic NAPT.
01/01/1970 00:00:00> Verify Firmware OK
01/01/1970 00:00:00> ZDev device loaded OK.
01/01/1970 00:00:00> CfgMgr: ';Shtm.dlz'; module loaded.
01/01/1970 00:00:00> CfgMgr: ';Washer.dlz'; module loaded.
01/01/1970 00:00:06> CfgMgr: ';Shtm.dlz'; module activated.
01/01/1970 00:00:06> CfgMgr: ';Washer.dlz'; module activated.
01/01/1970 00:00:17> ATM Connected
01/01/1970 00:00:17> ATM layer is up, cell delineation achieved
01/01/1970 00:00:17> ADSL connected
01/01/1970 00:00:17> Modulation: G.dmt
01/01/1970 00:00:17> Annex Mode: ANNEX_A
01/01/1970 00:00:17> Max Tx Power: -38dBm/Hz
01/01/1970 00:00:17> CO Vendor: TEXAS_INSTRUMENTS
01/01/1970 00:00:17> d/s SNR: 19.8dB, u/s SNR: 28.0dB
01/01/1970 00:00:17> d/s Attenuation: 54.3dB, u/s Attenuation: 31.5dB
01/01/1970 00:00:17> d/s Data Rate: 1024kbps, u/s Data Rate: 256kbps
01/01/1970 00:00:17> d/s Latency: FAST, u/s Latency: FAST
01/01/1970 00:00:17> d/s total bit capacity: 1088bits, used: 264bits
01/01/1970 00:00:17> u/s total bit capacity: 87bits, used: 87bits
01/01/1970 00:00:17> ATM Tx Error Count: 0, Rx Error Count: 0
01/01/1970 00:00:17> PPP1 PPPoE PADI Sent
这是我猫的系统日志，不知道能不能从中找出不能上网的原因，希望高手指点一二。

Sharv

高手帮帮忙呀。

wbh1414

我买好几个这猫了就是这么调的，肯定好使，要是还不好使那就是猫坏了！

zyr486

01/01/1970 00:00:17> PPP1 PPPoE PADI Sent
停住了，可能你的不是pppoe协议，是其他的

sharv

我用的pppoe协议是默认的pppoe-llc，换一个试试？谢谢提点。