Conexant芯片的猫刷坏了,如何补救????

ONLY

开始刷了21R60后,无法自动连接,系统日志到下面横线的地方就停了(下面是同样型号猫正常上线的日志):
01/01/1970 00:00:00> Ethernet Device 0 Detected
01/01/1970 00:00:00> ATM: Detected
01/01/1970 00:00:00> ATM: Setting up vcc0, VPI=8, VCI=81
01/01/1970 00:00:00> Initialized Dynamic NAPT.
01/01/1970 00:00:00> DNS: Add IP address 202.103.44.150 (User defined)
01/01/1970 00:00:00> DNS: Add IP address 202.103.24.68 (User defined)
01/01/1970 00:00:00> Verify Firmware OK
01/01/1970 00:00:00> ZDev device loaded OK.
01/01/1970 00:00:00> CfgMgr: ';Shtm.dlz'; module loaded.
01/01/1970 00:00:00> CfgMgr: ';Washer.dlz'; module loaded.
01/01/1970 00:00:06> CfgMgr: ';Shtm.dlz'; module activated.
01/01/1970 00:00:06> CfgMgr: ';Washer.dlz'; module activated.
01/01/1970 00:00:17> ATM Connected
01/01/1970 00:00:17> ATM layer is up, cell delineation achieved
01/01/1970 00:00:17> ADSL connected
01/01/1970 00:00:17> Modulation: G.dmt
01/01/1970 00:00:17> Annex Mode: ANNEX_A
01/01/1970 00:00:17> Max Tx Power: -38dBm/Hz
01/01/1970 00:00:17> CO Vendor: TEXAS_INSTRUMENTS
01/01/1970 00:00:17> d/s SNR: 31.6dB, u/s SNR: 24.0dB
01/01/1970 00:00:17> d/s Attenuation: 27.4dB, u/s Attenuation: 14.0dB
01/01/1970 00:00:17> d/s Data Rate: 4096kbps, u/s Data Rate: 512kbps
01/01/1970 00:00:17> d/s Latency: FAST, u/s Latency: FAST
01/01/1970 00:00:17> d/s total bit capacity: 3059bits, used: 1032bits
01/01/1970 00:00:17> u/s total bit capacity: 152bits, used: 152bits
01/01/1970 00:00:17> ATM Tx Error Count: 0, Rx Error Count: 0
01/01/1970 00:00:17> PPP1 PPPoE PADI Sent
--------------------------------------------------------------------------------
01/01/1970 00:00:23> PPP1 PPPoE PADR Sent, Service-Name: AC-Name:sybsn2
01/01/1970 00:00:23> PPP1 PPPoE PADS Received  Service-Name: AC-Name:sybsn2
01/01/1970 00:00:23> PPP1 PPPoE Session is established.
01/01/1970 00:00:23> PPP1 PAP Authentication success
01/01/1970 00:00:23> PPP1: PPP IP address is 219.139.85.54
01/01/1970 00:00:23> PPP1: PPP Gateway IP address is 58.52.61.2
01/01/1970 00:00:23> PPP1: DNS Primary IP address is 202.103.44.150
01/01/1970 00:00:23> PPP1: DNS Secondary IP address is 202.103.24.68
01/01/1970 00:00:23> NAT/NAPT Session Start: interface ppp1, WAN IP is 219.139.85.54
01/01/1970 00:00:23> No Static Session Information is defined.
01/01/1970 00:00:24> DNS: Add IP address 202.103.44.150 (Auto discovered)
01/01/1970 00:00:24> DNS: Add IP address 202.103.24.68 (Auto discovered)
01/01/1970 00:00:24> PPP1 Session is up.
01/01/1970 00:00:24> ppp_Comeup() : FAILED to send message to DDNS
11/13/2006 14:45:23> Received time from Time Server 128.138.140.44
11/13/2006 14:46:08> Send UPnP Connected
11/13/2006 14:46:11> Send UPnP Connected
11/13/2006 14:58:46> Send UPnP Connected
11/13/2006 15:06:39> UPnP Action:AddPortMapping State:Success. TCP-port:64210 Opened!
11/13/2006 15:06:39> UPnP Action:DeletePortMapping State:Success. TCP-port:64210 Closed!
11/14/2006 08:28:13> Send UPnP Connected
11/14/2006 08:47:47> UPnP Action:DeletePortMapping State:Success. TCP-port:64210 Closed!
又换了38R20和47R10,都一样的毛病.
后来又刷回21R50,用的是UPDATE,可是关机再开后却怎么也进不去猫了........
是什么原因???这个猫还有救么???

AMD

自己做线在DOS下重新刷新就OK了
很简单的在教程区有方法