openwrt要用RG100的cfe,120-wn的lan口与rg100一样
刷了OpenWrt Backfire 10.03.1-rc5没有无线,启动信息是看到了无线驱动加载成功- eth1: link forced UP - 100/full - flow control off/off
- device eth1 entered promiscuous mode
- br-lan: port 1(eth1) entering forwarding state
- Compat-wireless backport release: compat-wireless-2011-06-23
- Backport based on wireless-testing.git master-2011-06-22
- cfg80211: Calling CRDA to update world regulatory domain
- roboswitch: Probing device eth0: Failed to enable switch
- roboswitch: Probing device eth1: found a 5325! It's a 5350.
- cfg80211: World regulatory domain updated:
- cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
- cfg80211: (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
- cfg80211: (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
- cfg80211: (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
- cfg80211: (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
- cfg80211: (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
- Broadcom 43xx driver loaded [ Features: PL, GPIO LED Mask: 0x000f, Firmware-ID: FW13 ]
复制代码 |