找回密码
 注册

QQ登录

只需一步,快速开始

查看: 5508|回复: 15

刚刚找了一个CON芯片的4.1.0.38固件,和原来的不大一样的界面,已上传到网络硬盘

[复制链接]
发表于 2005-8-22 14:05:53 | 显示全部楼层 |阅读模式
[这个贴子最后由木鸟在 2005/08/22 02:36pm 第 1 次编辑]

NETCOMM的NB1300
NetComm NB1300 V6.1038.1SD ADSL Firmware Release Notes
Chipset: CX82xxx_4.1.0.38
08/07/2005
● SIP ALG fixed
● MTU path discovery fixed
● Fixed duplicated MAC address issue on Bridge learning module
● Fixed ADSL MIB
● Failure to detect Prism 802.11b wireless with Tahoe chipset
● Increase FreeBSD firewall port timeout.
● Config.reg is not saved after Update.reg was applied
● SNMP inbound/outbound issue resolved
● UPnP IGD device name resolved
● “\” character in PPP service name resolved
● DDNS Failed to update resolved
● SNMP settings changes to be permanent
● Flash and File Corruption fix.
● MXIC 4M flash support.
● DCC support in mIRC
● Tx LED – GPIO19
● SNMP access configurable
● Fixed Dynamic DNS system log
● Improved echo canceller performance
● Fixed intermittent SNMP over Clear EOC problem
● Fixed Calix DSLAM reset problem
● Fix downstream CRCs (medium length loops) with GSPN DSLAM
● Added PSD test mode for -26
● Added 10-PVC support
● Added USB enable and disable control in the Web page
● Fixed ALG support for Yahoo Messenger
● Added configurable names for login (user and admin)
● Added password checking with new password retype in the Web page
● Removed the minimum 8-character limit on the password
● Increased MAC address filter limit to 16 MAC addresses
● Added MAC address filtering with forward and block list
● Added ADSL status into the system log
● Added system log classification with events and warnings
● Increased MAC address support to 256 MAC addresses
● Allowed WLAN FCC parameters to be saved the flash
● Fixed the PPP Half Bridge problem with another router behind
● Fixed the 2nd DNS address receiving problem
● Fixed the double quotation mark problem with Web page entries
● Fixed the PPP timeout problem during the FTP session
● Enhanced the PPP operation to avoid the long connection timeout
● Enhanced the WAN DHCP client operation to avoid the timeout for getting an IP
● Added error checking for the HTTP port range
● Added passphrase for the WEP key
● Added secret WLAN AP feature to hide the SSID
● Added AP BSSID display
● Added WLAN AP open system or shared key authentication
● Fixed WLAN bridge mode throughput problem
● Fixed AP BSSID MAC address problem
● Added WLAN LED on GPIO 7 (LEDMODE = 0A)
● Fixed Web page login problem with Sony Play Station
● Fixed Web page problem with Netscape 7.1
● Fixed the FTP port 21 mapping problem with private ports
● Fixed PPP Half Bridge IP problem with repetitive release/renew
● Changed the showtime module into two: SHTM.DLZ is for regular showtime and
SHTMDTST.DLZ is for debugging only
DSLAM Fixes:
● Fixed the long connection time with the Sumitomo Centillium DSLAM
● Improved SNR margin for Telefonica in T1.413 mode
● Improved the downstream rate for 11 kft/24hdsl loop
● Improved the bit swap algorithm
● Improved upstream performance with the Lucent Centillium DSLAM
● Improved upstream rates on the short loops with the Nokia 4-port ETSI DSLAM
● Fixed problem in Nokia 4-port ETSI DSLAM
● Improved the downstream rate for GSPN in T1.413 mode
● Fixed the short loops problem with the ADI 400B & 408 DSLAMs
● Reduced the CRCs in T1.413 mode for Covad qualification
● Improved detection of T1.413 C_ACK tones in noisy environments
● Fixed the Clear EOC transmit buffer potential overflow problem
● Improved the performance and CRC reduction for Alcatel 7300
● Fixed the showtime problem when CO in G.Lite mode and CPE in auto-sense mode with the
Lucent GSPN DSLAM
● Fixed CRC problem with KT Alcatel DSLAMs
● Eliminated upstream DSLAM SNR margin problem during showtime for Annex B Alcatel
DSLAM’s
● Eliminated long T1.413 connection problem with CSA #6 mid loop
● Improved the performance of the short loops, such as CSA4 with 24HDSL noise, with the
Alcatel DSLAMs
 楼主| 发表于 2005-8-22 14:08:14 | 显示全部楼层

刚刚找了一个CON芯片的4.1.0.38固件,和原来的不大一样的界面,已上传到网络硬盘

There are eleven areas that need your attention to secure your NB1300 from
unauthorised access - these areas or features are;

*  Physical Security
*  Admin Password
*  User Password
*  SNMP Community Strings (when SNMP is available in your firmware)
*  FTP server
*  HTTP Server
*  DMZ Host
These options are all found under ‘Misc Configuration’
*  Half Bridge mode}   
*  Port Forwarding
*  Dynamic Routing (RIP Configuration)
*  Telnet
呵呵,支持的好像比TELEWELL的多。
 楼主| 发表于 2005-8-22 14:11:39 | 显示全部楼层

刚刚找了一个CON芯片的4.1.0.38固件,和原来的不大一样的界面,已上传到网络硬盘

类似于大亚原来的那种,有隐藏界面。
05年8月7日发布。
呵呵,这个是看到YES东发布的VIKING2芯片NETCOMM的固件,我就去他的网站逛了一圈,还真有点收获。
想要的联系我好了,VDISK的网络硬盘上不去了。不然直接传到里面。[br][br]-=-=-=-=- 以下内容由 木鸟2005年08月22日 02:14pm 时添加 -=-=-=-=-
还有USB驱动和设置工具[br][br]-=-=-=-=- 以下内容由 木鸟2005年08月22日 02:32pm 时添加 -=-=-=-=-
已经上传到我的网络硬盘了,http://woodbird.ys168.com
DLF固件,说明,驱动,设置工具都在里面。
呵呵,再次警告一句,不会USB刷新的不要动手刷这个。
发表于 2005-8-22 15:37:51 | 显示全部楼层

刚刚找了一个CON芯片的4.1.0.38固件,和原来的不大一样的界面,已上传到网络硬盘

这句什么意思?DDNS Failed to update resolved
发表于 2005-8-22 15:44:49 | 显示全部楼层

刚刚找了一个CON芯片的4.1.0.38固件,和原来的不大一样的界面,已上传到网络硬盘

解决DDNS服务更新失败,就是modem更新不了DDNS服务器上面的地址信息~~
 楼主| 发表于 2005-8-22 15:47:01 | 显示全部楼层

刚刚找了一个CON芯片的4.1.0.38固件,和原来的不大一样的界面,已上传到网络硬盘

应该是DDNS更新失败吧?
或者是日志里面的那句
Failed to SEND什么的。
发表于 2005-8-22 15:57:00 | 显示全部楼层

刚刚找了一个CON芯片的4.1.0.38固件,和原来的不大一样的界面,已上传到网络硬盘

有下载地址吗?
 楼主| 发表于 2005-8-22 15:59:10 | 显示全部楼层

刚刚找了一个CON芯片的4.1.0.38固件,和原来的不大一样的界面,已上传到网络硬盘

看帖子不仔细,在我的网络硬盘里面
http://woodbird.ys168.com
确认可以用USB刷新再下载哦。这个是DLF文件的。
发表于 2005-8-22 16:02:25 | 显示全部楼层

刚刚找了一个CON芯片的4.1.0.38固件,和原来的不大一样的界面,已上传到网络硬盘

呵呵,看看有什么特别的。不用USB。DLF我都用dlf工具解开后,做批处理文件来刷的
 楼主| 发表于 2005-8-22 16:04:34 | 显示全部楼层

刚刚找了一个CON芯片的4.1.0.38固件,和原来的不大一样的界面,已上传到网络硬盘

[这个贴子最后由木鸟在 2005/08/22 04:05pm 第 1 次编辑]

呵呵,里面还有驱动和工具。
现在用的这个USB没焊,所以我还没动手呢。等一会刷,你成白老鼠了。
*滑块验证:
您需要登录后才可以回帖 登录 | 注册

本版积分规则

Archiver|小黑屋|宽带技术网 |网站地图 粤公网安备44152102000001号

GMT+8, 2025-6-10 03:13 , Processed in 0.058136 second(s), 4 queries , Redis On.

Powered by Discuz! X3.5 Licensed

Copyright © 2001-2020, Tencent Cloud.

快速回复 返回顶部 返回列表