H608b 挂了，请高手帮忙！

xman890105

我有一个H608b（外置天线的）我在换里面的文件时出问题，现在power常亮，run也常亮。
192.168.1.1不能打开，不能FTP，不能telnet。

用ttl线连上后出现以下，就卡死了。输入也没有用。

1. 
   
2. ZXV10 HGW bootloader V1.9
   
3. SDRAM size = 0x2000000-------->
   
4. Hardware version is 1-------->
   
5. Processor clock speed 264.0MHz
   
6. FLASH size = 0x1000000-------->
   
7. Finding flashfs partition ...@ offset 00540000
   
8. Finding flashfs partition ...@ offset 00620000
   
9. 2 partition found
   
10. Boot from image A @ offset 00540000
    
11. done.
    
12. Image 'image' is a Linux kernel
    
13. Trying to load initrd...none found
    
14. Calling Configure_NVS_FromFile.
    
15. LZMA 4.05
    
16. 00bXLinux version 2.6.11.12 (xia@localhost.localdomain) (gcc version 4.0.1) #138 Wed Aug 20 14:03:53 CST 2008
    
17. CPU: ARM1026EJ-Sid(wb)B [4106a262] revision 2 (ARMv5TEJ)
    
18. CPU0: D VIVT write-back cache
    
19. CPU0: I cache: 16384 bytes, associativity 4, 32 byte lines, 128 sets
    
20. CPU0: D cache: 8192 bytes, associativity 4, 32 byte lines, 64 sets
    
21. Machine: Solos CX46xx, unknown variant
    
22. !!!!!!!
    
23. 
    
24. the hw id is 1,
    
25. !!!!!!Memory policy: ECC disabled, Data cache writeback
    
26. Built 1 zonelists
    
27. Kernel command line: console=ttyS0 root=31:4 rw mem=31M mtdparts=phys_mapped_flash:256k(boot),1024k(kernel),4992k(JFFS2),1024k(k2),4992k(J2),-(CT) rootfstype=jffs2
    
28. init_dma not supported
    
29. PID hash table entries: 128 (order: 7, 2048 bytes)
    
30. Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
    
31. Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
    
32. Memory: 31MB = 31MB total
    
33. Memory: 28980KB available (1959K code, 379K data, 76K init)
    
34. Mount-cache hash table entries: 512 (order: 0, 4096 bytes)
    
35. CPU: Testing write buffer coherency: ok
    
36. NET: Registered protocol family 16
    
37. Generic PHY: Registered new driver
    
38. SCSI subsystem initialized
    
39. usbcore: registered new driver hub
    
40. NetWinder Floating Point Emulator V0.97 (double precision)
    
41. JFFS2 version 2.2. (C) 2001-2003 Red Hat, Inc.
    
42. Initializing Cryptographic API
    
43. Ledkey Driver Version 0.0.1.
    
44. ledkey : ===== ledkey_init =====
    
45. init watchdog!!!
    
46. zteinfo_init
    
47. Solos on-chip UART init.
    
48. ttyS0 at I/O 0x0 (irq = 29) is a Solos UART
    
49. io scheduler noop registered
    
50. RTL18305SD: Registered new driver
    
51. PPP generic driver version 2.4.2
    
52. NET: Registered protocol family 24
    
53. physmap flash device: 1000000 at 38000000
    
54. phys_mapped_flash: Found 1 x16 devices at 0x0 in 8-bit bank
    
55. Amd/Fujitsu Extended Query Table at 0x0040
    
56. phys_mapped_flash: CFI does not contain boot bank location. Assuming top.
    
57. number of CFI chips: 1
    
58. cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness.
    
59. Creating 8 MTD partitions on "phys_mapped_flash":
    
60. 0x00000000-0x01000000 : "flash"
    
61. 0x00000000-0x00020000 : "Bootloader"
    
62. 0x00020000-0x00040000 : "config"
    
63. 0x00540000-0x00620000 : "kernel"
    
64. 0x00040000-0x00540000 : "filesystem"
    
65. 0x00620000-0x00700000 : "kernel2"
    
66. 0x00700000-0x00c00000 : "filesystem2"
    
67. 0x00c00000-0x01000000 : "ct-jffs2"
    
68. Solos-W EHCI starting up...
    
69. solosW-ehci usb00: Solos USB 2.0
    
70. solosW-ehci usb00: irq 9, pci mem ff800100
    
71. solosW-ehci usb00: new USB bus registered, assigned bus number 1
    
72. wlan short push
    
73. solosW-ehci usb00: park 0
    
74. solosW-ehci usb00: USB 0.0 initialized, EHCI 1.00, driver 10 Dec 2004
    
75. usb usb1: Product: Solos USB 2.0
    
76. usb usb1: Manufacturer: Linux 2.6.11.12 ehci_hcd
    
77. usb usb1: SerialNumber: Solos EHCI
    
78. hub 1-0:1.0: USB hub found
    
79. hub 1-0:1.0: 1 port detected
    
80. INTR_MASK 37, 37
    
81. Initializing USB Mass Storage driver...
    
82. usbcore: registered new driver usb-storage
    
83. USB Mass Storage support registered.
    
84. u32 classifier
    
85. OLD policer on
    
86. NET: Registered protocol family 2
    
87. IP: routing cache hash table of 512 buckets, 4Kbytes
    
88. TCP established hash table entries: 1024 (order: 1, 8192 bytes)
    
89. TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
    
90. TCP: Hash tables configured (established 1024 bind 1024)
    
91. IPv4 over IPv4 tunneling driver
    
92. ip_conntrack version 2.1 (248 buckets, 1984 max) - 320 bytes per conntrack
    
93. usb 1-1: new high speed USB device using solosW-ehci and address 2
    
94. usb 1-1: Product: Flash Disk
    
95. usb 1-1: Manufacturer: CBM
    
96. ip_tables: (C) 2000-2002 Netfilter core team
    
97. usb 1-1: SerialNumber: 1211500035B27500
    
98. scsi0 : SCSI emulation for USB Mass Storage devices
    
99. ip_conntrack_rtsp v0.01 loading
    
100. ip_nat_rtsp v0.01 loading
     
101. netfilter PSD loaded - (c) astaro AG
     
102. Initializing IPsec netlink socket
     
103. NET: Registered protocol family 1
     
104. NET: Registered protocol family 17
     
105. NET: Registered protocol family 15
     
106. Please set the MAC Address for the WAN Bridge.
     
107. Set the Environment variable 'wan_br_mac'.
     
108. MAC Address should be in the following format: xx.xx.xx.xx.xx.xx
     
109. Ebtables v2.0 registered
     
110. NET: Registered protocol family 8
     
111. NET: Registered protocol family 20
     
112. 802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
     
113. All bugs added by David S. Miller <davem@redhat.com>
     
114. VFS: Mounted root (jffs2 filesystem).
     
115. Freeing init memory: 76K
     
116. Kernel panic - not syncing: No init found. Try passing init= option to kernel.

复制代码

一直这样，也不重启，求高手帮忙！！