刷上了. 不懂玩这个OPENWRT,看来得加强学习啊.
- CFE version 1.0.37-8.7 for AGPF 0007 BCM96358 (32bit,SP,BE)
- Build Date: lun giu 16 10:47:46 CEST 2008 ( gpaolo@buildserver )
- Copyright (C) 2000-2005 Broadcom Corporation.
- Boot Address 0xbe000000
- Initializing Arena.
- Initializing Devices.
- Flash info:
- device_id : ............227E
- meminfo.nsect:..........128
- totalSize:..............1000000
- num_erase_blocks:...... 1
- device_size:............1000000
- Parallel flash device: name MX29L128DT, id 0x227e, size 16384KB
- CPU type 0x2A010: 300MHz, Bus: 133MHz, Ref: 64MHz
- CPU running TP0
- Total memory: 67108864 bytes (64MB)
- Total memory used by CFE: 0x80401000 - 0x80528CB0 (1211568)
- Initialized Data: 0x8041E8A0 - 0x804204C0 (7200)
- BSS Area: 0x804204C0 - 0x80426CB0 (26608)
- Local Heap: 0x80426CB0 - 0x80526CB0 (1048576)
- Stack Area: 0x80526CB0 - 0x80528CB0 (8192)
- Text (code) segment: 0x80401000 - 0x8041E894 (120980)
- Boot area (physical): 0x00529000 - 0x00569000
- Relocation Factor: I:00000000 - D:00000000
- Board IP address : 192.168.1.1:ffffff00
- Host IP address : 192.168.1.20
- Gateway IP address :
- Run from flash/host (f/h) : f
- Default host run file name : vmlinux
- Default host flash file name : openwrt-AGPF-S0-squashfs-cfe.bin
- Boot delay (0-9 seconds) : 2
- Board Id (0-3) : AGPF-S0
- Number of MAC Addresses (1-32) : 10
- Base MAC Address : 00:03:0f:0e:d9:2b
- PSI Size (1-64) KBytes : 64
- Main Thread Number [0|1] : 0
- *** Press any key to stop auto run (2 seconds) ***
- Auto run second count down: 0
- Sizeof Tag Used : 256
- One only valid image tag found ...
- Trying to boot from FIRST image copy (0x80010000) ...
- latest imageSequence found: ... 0
- - Flash Kernel Address: 0xBE020100
- - Tag->kernelLen: 0x000BE17D
- - Flash Kernel Address: 0xBE020100
- - Tag Kernel crc : 0x059DD614 - calculated: 0x059DD614
- Decompression OK! - starting 0
- Entry at 0x80010000
- Distribution:
- Version:
- Build Date:
- Closing network.
- Starting program at 0x80010000
- SGP START PARTITION: 0
- Linux version 2.6.27.19 (buildbot@localhost.localdomain) (gcc version 4.1.2) #5 Tue Mar 24 15:32:32 CDT 2009
- Detected Broadcom 0x6358 CPU revision a1
- CPU frequency is 300000000 Hz
- 64MB of RAM installed
- board_bcm963xx: CFE version: unknown
- console [early0] enabled
- CPU revision is: 0002a010 (Broadcom BCM6358)
- board_bcm963xx: board name: AGPF-S0
- Determined physical RAM map:
- memory: 04000000 @ 00000000 (usable)
- Initrd not found or empty - disabling initrd
- Zone PFN ranges:
- Normal 0x00000000 -> 0x00004000
- Movable zone start PFN for each node
- early_node_map[1] active PFN ranges
- 0: 0x00000000 -> 0x00004000
- Built 1 zonelists in Zone order, mobility grouping on. Total pages: 16256
- Kernel command line: root=/dev/mtdblock2 rootfstype=squashfs,jffs2 init=/etc/preinit noinitrd console=ttyS0,115200
- Primary instruction cache 32kB, VIPT, 2-way, linesize 16 bytes.
- Primary data cache 16kB, 2-way, VIPT, cache aliases, linesize 16 bytes
- PID hash table entries: 256 (order: 8, 1024 bytes)
- Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
- Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
- Memory: 62352k/65536k available (1891k kernel code, 3116k reserved, 329k data, 120k init, 0k highmem)
- Calibrating delay loop... 299.00 BogoMIPS (lpj=598016)
- Mount-cache hash table entries: 512
- net_namespace: 592 bytes
- NET: Registered protocol family 16
- registering 37 GPIOs
- registering PCI controller with io_map_base unset
- bus: 00 index 0 io port: [8000000, 800ffff]
- bus: 00 index 1 mmio: [30000000, 37ffffff]
- PCI: Enabling device 0000:00:01.0 (0000 -> 0002)
- ssb: Sonics Silicon Backplane found on PCI device 0000:00:01.0
- NET: Registered protocol family 2
- IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
- TCP established hash table entries: 2048 (order: 2, 16384 bytes)
- TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
- TCP: Hash tables configured (established 2048 bind 2048)
- TCP reno registered
- NET: Registered protocol family 1
- audit: initializing netlink socket (disabled)
- type=2000 audit(0.367:1): initialized
- squashfs: version 3.0 (2006/03/15) Phillip Lougher
- Registering mini_fo version $Id$
- JFFS2 version 2.2. (NAND) (SUMMARY) © 2001-2006 Red Hat, Inc.
- msgmni has been set to 121
- io scheduler noop registered
- io scheduler cfq registered (default)
- bcm63xx_uart.0: ttyS0 at MMIO 0xfffe0100 (irq = 10) is a bcm63xx_uart
- console handover: boot [early0] -> real [ttyS0]
- bcm63xx_enet MII bus: probed
- bcm963xx_flash: 0x02000000 at 0x1e000000
- bcm963xx: Found 1 x16 devices at 0x0 in 16-bit bank
- Amd/Fujitsu Extended Query Table at 0x0040
- bcm963xx: CFI does not contain boot bank location. Assuming top.
- number of CFI chips: 1
- cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness.
- bcm963xx_flash: Read Signature value of CFE1CFE1
- bcm963xx_flash: CFE bootloader detected
- bcm963xx_flash: CFE boot tag found with version 8 and board type AGPF-S0.
- bcm963xx_flash: Partition 0 is CFE offset 0 and length 20000
- bcm963xx_flash: Partition 1 is kernel offset 20100 and length be17d
- bcm963xx_flash: Partition 2 is rootfs offset 157b20 and length ee20e4
- bcm963xx_flash: Partition 3 is nvram offset fe0000 and length 20000
- Creating 4 MTD partitions on "bcm963xx":
- 0x00000000-0x00020000 : "CFE"
- 0x00020100-0x000de27d : "kernel"
- mtd: partition "kernel" doesn't start on an erase block boundary -- force read-only
- 0x00157b20-0x01039c04 : "rootfs"
- mtd: partition "rootfs" extends beyond the end of device "bcm963xx" -- size truncated to 0xea84e0
- mtd: partition "rootfs" doesn't start on an erase block boundary -- force read-only
- mtd: partition "rootfs" set to be root filesystem
- mtd: partition "rootfs_data" created automatically, ofs=360000, len=CD9C04
- 0x00360000-0x01039c04 : "rootfs_data"
- mtd: partition "rootfs_data" extends beyond the end of device "bcm963xx" -- size truncated to 0xca0000
- 0x00fe0000-0x01000000 : "nvram"
- TCP bic registered
- NET: Registered protocol family 17
- 802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
- All bugs added by David S. Miller <davem@redhat.com>
- VFS: Mounted root (squashfs filesystem) readonly.
- Freeing unused kernel memory: 120k freed
- Please be patient, while OpenWrt loads ...
- Algorithmics/MIPS FPU Emulator v1.5
- - preinit -
- Press CTRL-C for failsafe
- switching to jffs2
- mini_fo: using base directory: /
- mini_fo: using storage directory: /jffs
- - init -
- Please press Enter to activate this console. bcm63xx_enet bcm63xx_enet.0: attached PHY at address 1 [Broadcom BCM63XX (2)]
- bcm63xx_enet bcm63xx_enet.0: attached PHY at address 1 [Broadcom BCM63XX (2)]
- eth1: link forced UP - 100/full - flow control off/off
- device eth1 entered promiscuous mode
- br-lan: topology change detected, propagating
- br-lan: port 1(eth1) entering forwarding state
- cfg80211: Using static regulatory domain info
- cfg80211: Regulatory domain: US
- (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
- (2402000 KHz - 2472000 KHz @ 40000 KHz), (600 mBi, 2700 mBm)
- (5170000 KHz - 5190000 KHz @ 40000 KHz), (600 mBi, 2300 mBm)
- (5190000 KHz - 5210000 KHz @ 40000 KHz), (600 mBi, 2300 mBm)
- (5210000 KHz - 5230000 KHz @ 40000 KHz), (600 mBi, 2300 mBm)
- (5230000 KHz - 5330000 KHz @ 40000 KHz), (600 mBi, 2300 mBm)
- (5735000 KHz - 5835000 KHz @ 40000 KHz), (600 mBi, 3000 mBm)
- cfg80211: Calling CRDA for country: US
- br-lan: port 1(eth1) entering disabled state
- br-lan: topology change detected, propagating
- br-lan: port 1(eth1) entering forwarding state
- roboswitch: Probing device eth0: Failed to enable switch
- roboswitch: Probing device eth1: found!
- b43-phy0: Broadcom 4318 WLAN found (core revision 9)
- Broadcom 43xx driver loaded [ Features: PL, Firmware-ID: FW13 ]
- PPP generic driver version 2.4.2
- tun: Universal TUN/TAP device driver, 1.6
- tun: (C) 1999-2004 Max Krasnyansky <maxk@qualcomm.com>
- ip_tables: (C) 2000-2006 Netfilter Core Team
- nf_conntrack version 0.5.0 (1024 buckets, 4096 max)
|
粤公网安备44152102000001号 
发表于 2009-5-2 19:14:13
发表于 2009-5-3 12:09:04