|
|
ttl输出为
SPI NAND
start read bootloader
secure boot
CBC decrypt OK!
CBC decrypt OK!
CBC decrypt OK!
verify OK!
Jump
enter bootloader...
pll init, cpu freq=1000 MHz
crpm init ok
product_vid=77
DDR3 size, 0x20000000=512MiB,HALF_MODE=0
DDR3 1333 Mbps
ddr init ok
SPI NAND
ncfg:1
0,40,b,800
secure uboot
verify OK!
backup header!!
Jump
U-Boot 2021.01 (Mar 03 2024 - 03:42:05 +0800)
CPU : ZX279133@A53x2,1000MHZ
Model: ZTE 133
DRAM: 512 MiB
Relocation Offset is: 1d6a8000
clk_register: failed to get sd_wclk_mux device (parent of sd_wclk_div), idx = 0
clk_register: failed to get nand_xclk device (parent of nand_wclk), idx = 1
clk_register: failed to get clk1376m_div device (parent of pon_core_clk_mux), idx = 2
clk_register: failed to get clk40m device (parent of pcie_25m_mux), idx = 3
clk_register: failed to get pon_tm_aclk device (parent of tzc400_pon_aclk), idx = 4
product_vid = 77
vid=77-G7615V2
mtk reset,66
boot_ctrl value=====3
bootsel=3
Disable watchdog.
el=3
NAND: zs->cs_regmap 0000000000000000
zx_sfc_probe: enter
zx_sfc_probe: done
spi_nand spi-flash@0: READ ID data: 01-25-01, skyhigh SPI NAND was found.
spi_nand spi-flash@0: 256 MiB, block size: 128 KiB, page size: 2048, OOB size: 128
spinand name:spi-nand0
Creating 14 MTD partitions on "spi-nand0":
0 MiB
Loading Environment from NAND... OK
In: serial
Out: serial
Err: serial
clk_pll env is not setted, core clk won't change
Net: rx data disable
innerGeLedPolarSet 1
innerGeLedPolarSet 1
innerGeLedPolarSet 1
innerGeLedPolarSet 1
mdio_miiphy_initialize ok
eth0
sec mode!
Hit 1 to upgrade software version
Hit any key to stop autoboot: 0
=>
|
|
/1 
44152102000001
发表于 