我的猫升级为4.1.0.28了，但test灯一直闪：（

no66866

我的线路可能很不好，经常断线，还达不到最高值：（
升级后，猫的五个灯都亮，有闪的，有一直亮的：（
以前是四个灯亮，test灯不亮，可现在test灯一直亮，好像是自检有问题
请高手帮帮忙

no66866

01/01/1970 00:00:00> Ethernet Device 0 Detected
01/01/1970 00:00:00> ATM: Detected
01/01/1970 00:00:00> ATM: Setting up vcc0, VPI=0, VCI=35
01/01/1970 00:00:00> Initialized Dynamic NAPT.
01/01/1970 00:00:00> Verify Firmware OK
01/01/1970 00:00:00> ZDev device loaded OK.
01/01/1970 00:00:00> CfgMgr: ';Shtm.dlz'; module loaded.
01/01/1970 00:00:00> NAT/NAPT Session Start: interface ss0, WAN IP is 222.138.12.253
01/01/1970 00:00:00> NAPT: Conexant session is up.
01/01/1970 00:00:05> CfgMgr: ';Washer.dlz'; module loaded.
01/01/1970 00:00:16> ATM Connected
01/01/1970 00:00:16> ATM layer is up, cell delineation achieved
01/01/1970 00:00:16> ADSL connected
01/01/1970 00:00:16> Modulation: G.dmt
01/01/1970 00:00:16> Annex Mode: ANNEX_A
01/01/1970 00:00:16> Max Tx Power: -38dBm/Hz
01/01/1970 00:00:16> CO Vendor: TEXAS_INSTRUMENTS
01/01/1970 00:00:16> d/s SNR: 12.8dB, u/s SNR: 18.0dB
01/01/1970 00:00:16> d/s Attenuation: 42.4dB, u/s Attenuation: 25.0dB
01/01/1970 00:00:16> d/s Data Rate: 4096kbps, u/s Data Rate: 640kbps
01/01/1970 00:00:16> d/s Latency: INTERLEAVED, u/s Latency: INTERLEAVED
01/01/1970 00:00:16> d/s total bit capacity: 1442bits, used: 1048bits
01/01/1970 00:00:16> u/s total bit capacity: 185bits, used: 185bits
01/01/1970 00:00:16> ATM Tx Error Count: 0, Rx Error Count: 0
01/02/2005 13:54:03> Received time from Time Server 192.43.244.18
这是日志文件，帮我看看有问题吗
猫还是五个灯全亮

goingchan

把调制类型改为其它的类型试试。。。不过，你那的线路的确本身有很大问题。。。