刚刚找了一个CON芯片的4.1.0.38固件，和原来的不大一样的界面，已上传到网络硬盘
[这个贴子最后由木鸟在 2005/08/22 02:36pm 第 1 次编辑]NETCOMM的NB1300
NetComm NB1300 V6.1038.1SD ADSL Firmware Release Notes
Chipset: CX82xxx_4.1.0.38
08/07/2005
● SIP ALG fixed
● MTU path discovery fixed
● Fixed duplicated MAC address issue on Bridge learning module
● Fixed ADSL MIB
● Failure to detect Prism 802.11b wireless with Tahoe chipset
● Increase FreeBSD firewall port timeout.
● Config.reg is not saved after Update.reg was applied
● SNMP inbound/outbound issue resolved
● UPnP IGD device name resolved
● “\” character in PPP service name resolved
● DDNS Failed to update resolved
● SNMP settings changes to be permanent
● Flash and File Corruption fix.
● MXIC 4M flash support.
● DCC support in mIRC
● Tx LED – GPIO19
● SNMP access configurable
● Fixed Dynamic DNS system log
● Improved echo canceller performance
● Fixed intermittent SNMP over Clear EOC problem
● Fixed Calix DSLAM reset problem
● Fix downstream CRCs (medium length loops) with GSPN DSLAM
● Added PSD test mode for -26
● Added 10-PVC support
● Added USB enable and disable control in the Web page
● Fixed ALG support for Yahoo Messenger
● Added configurable names for login (user and admin)
● Added password checking with new password retype in the Web page
● Removed the minimum 8-character limit on the password
● Increased MAC address filter limit to 16 MAC addresses
● Added MAC address filtering with forward and block list
● Added ADSL status into the system log
● Added system log classification with events and warnings
● Increased MAC address support to 256 MAC addresses
● Allowed WLAN FCC parameters to be saved the flash
● Fixed the PPP Half Bridge problem with another router behind
● Fixed the 2nd DNS address receiving problem
● Fixed the double quotation mark problem with Web page entries
● Fixed the PPP timeout problem during the FTP session
● Enhanced the PPP operation to avoid the long connection timeout
● Enhanced the WAN DHCP client operation to avoid the timeout for getting an IP
● Added error checking for the HTTP port range
● Added passphrase for the WEP key
● Added secret WLAN AP feature to hide the SSID
● Added AP BSSID display
● Added WLAN AP open system or shared key authentication
● Fixed WLAN bridge mode throughput problem
● Fixed AP BSSID MAC address problem
● Added WLAN LED on GPIO 7 (LEDMODE = 0A)
● Fixed Web page login problem with Sony Play Station
● Fixed Web page problem with Netscape 7.1
● Fixed the FTP port 21 mapping problem with private ports
● Fixed PPP Half Bridge IP problem with repetitive release/renew
● Changed the showtime module into two: SHTM.DLZ is for regular showtime and
SHTMDTST.DLZ is for debugging only
DSLAM Fixes:
● Fixed the long connection time with the Sumitomo Centillium DSLAM
● Improved SNR margin for Telefonica in T1.413 mode
● Improved the downstream rate for 11 kft/24hdsl loop
● Improved the bit swap algorithm
● Improved upstream performance with the Lucent Centillium DSLAM
● Improved upstream rates on the short loops with the Nokia 4-port ETSI DSLAM
● Fixed problem in Nokia 4-port ETSI DSLAM
● Improved the downstream rate for GSPN in T1.413 mode
● Fixed the short loops problem with the ADI 400B & 408 DSLAMs
● Reduced the CRCs in T1.413 mode for Covad qualification
● Improved detection of T1.413 C_ACK tones in noisy environments
● Fixed the Clear EOC transmit buffer potential overflow problem
● Improved the performance and CRC reduction for Alcatel 7300
● Fixed the showtime problem when CO in G.Lite mode and CPE in auto-sense mode with the
Lucent GSPN DSLAM
● Fixed CRC problem with KT Alcatel DSLAMs
● Eliminated upstream DSLAM SNR margin problem during showtime for Annex B Alcatel
DSLAM’s
● Eliminated long T1.413 connection problem with CSA #6 mid loop
● Improved the performance of the short loops, such as CSA4 with 24HDSL noise, with the
Alcatel DSLAMs
刚刚找了一个CON芯片的4.1.0.38固件，和原来的不大一样的界面，已上传到网络硬盘
There are eleven areas that need your attention to secure your NB1300 fromunauthorised access - these areas or features are;
*Physical Security
*Admin Password
*User Password
*SNMP Community Strings (when SNMP is available in your firmware)
*FTP server
*HTTP Server
*DMZ Host
These options are all found under ‘Misc Configuration’
*Half Bridge mode}
*Port Forwarding
*Dynamic Routing (RIP Configuration)
*Telnet
呵呵，支持的好像比TELEWELL的多。
刚刚找了一个CON芯片的4.1.0.38固件，和原来的不大一样的界面，已上传到网络硬盘
类似于大亚原来的那种，有隐藏界面。05年8月7日发布。
呵呵，这个是看到YES东发布的VIKING2芯片NETCOMM的固件，我就去他的网站逛了一圈，还真有点收获。
想要的联系我好了，VDISK的网络硬盘上不去了。不然直接传到里面。-=-=-=-=- 以下内容由 木鸟 在 2005年08月22日 02:14pm 时添加 -=-=-=-=-
还有USB驱动和设置工具-=-=-=-=- 以下内容由 木鸟 在 2005年08月22日 02:32pm 时添加 -=-=-=-=-
已经上传到我的网络硬盘了，http://woodbird.ys168.com
DLF固件，说明，驱动，设置工具都在里面。
呵呵，再次警告一句，不会USB刷新的不要动手刷这个。
刚刚找了一个CON芯片的4.1.0.38固件，和原来的不大一样的界面，已上传到网络硬盘
这句什么意思？DDNS Failed to update resolved刚刚找了一个CON芯片的4.1.0.38固件，和原来的不大一样的界面，已上传到网络硬盘
解决DDNS服务更新失败，就是modem更新不了DDNS服务器上面的地址信息~~刚刚找了一个CON芯片的4.1.0.38固件，和原来的不大一样的界面，已上传到网络硬盘
应该是DDNS更新失败吧？或者是日志里面的那句
Failed to SEND什么的。
刚刚找了一个CON芯片的4.1.0.38固件，和原来的不大一样的界面，已上传到网络硬盘
有下载地址吗？刚刚找了一个CON芯片的4.1.0.38固件，和原来的不大一样的界面，已上传到网络硬盘
看帖子不仔细，在我的网络硬盘里面http://woodbird.ys168.com
确认可以用USB刷新再下载哦。这个是DLF文件的。
刚刚找了一个CON芯片的4.1.0.38固件，和原来的不大一样的界面，已上传到网络硬盘
呵呵，看看有什么特别的。不用USB。DLF我都用dlf工具解开后，做批处理文件来刷的刚刚找了一个CON芯片的4.1.0.38固件，和原来的不大一样的界面，已上传到网络硬盘
[这个贴子最后由木鸟在 2005/08/22 04:05pm 第 1 次编辑]呵呵，里面还有驱动和工具。
现在用的这个USB没焊，所以我还没动手呢。等一会刷，你成白老鼠了。
页:
[1]
2