请大神帮忙看下怎么操作?
之前发了这个帖子是在路由器连接TTL线通电后出现的开机自检信息，帖子详情：https://www.chinadsl.net/forum.php?mod=viewthread&tid=171246&extra=，这次我按紧复位键插电源后，貌似进入自动刷机模式，显示TFTP，但具体要怎么操作，谁能看懂指导我一下，谢谢！U-Boot 1.1.3 (Oct9 2013 - 09:14:54)
Board: Ralink APSoC DRAM:64 MB
relocate_code Pointer at: 83fb0000
Set info->start=BC000000
flash_protect ON: from 0xBC000000 to 0xBC01D24B
flash_protect ON: from 0xBC030000 to 0xBC030FFF
*** Warning - bad CRC, using default environment
============================================
Ralink UBoot Version: 4.1.1.0
--------------------------------------------
ASIC 3883_MP (MAC to Realtek Mode)
DRAM component: 512 Mbits DDR, width 16
DRAM bus: 16 bit
Total memory: 64 MBytes
Flash component: NOR Flash
Date:Oct9 2013Time:09:14:54
============================================
icache: sets:512, ways:4, linesz:32 ,total:65536
dcache: sets:256, ways:4, linesz:32 ,total:32768
##### The CPU freq = 480 MHZ ####
estimate memory size =64 Mbytes
Reset pressed, entering rescue mode!
10: System Load Firmware then write to Flash via TFTP.
Input device IP (192.168.1.123) Input server IP (192.168.1.100)Input Linux Kernel filename ()
netboot_common, argc= 3
NetTxPacket = 0x83FE5900
KSEG1ADDR(NetTxPacket) = 0xA3FE5900
NetLoop,call eth_halt !
NetLoop,call eth_init !
Trying Eth0 (10/100-M)
Waitting for RX_DMA_BUSY status Start... done
Realtek giga Mac support
GPIO pin 24 reset to switch
ETH_STATE_ACTIVE!!
TFTP from server 192.168.1.100; our IP address is 192.168.1.123
Filename 'firmware.bin'.
TIMEOUT_COUNT=10,Load address: 0x80100000
Loading: T T
都几天了，连个高手来指点一下都没有？
页:
[1]