求华为HS8545M救砖!!!
本帖最后由 tao8886999 于 2020-2-4 19:21 编辑华为HS8545M移动版因刷错固件变转，电源指示灯亮，网口通。接TTL线终端显示如下信息：
HuaWei StartCode 2012.02 (V300R017C10 Sep 07 2017 - 11:54:40)
NAND:Nand ID: 0xC2 0xDA 0x90 0x95 0x06 0x00 0x00 0x00
ECC Match pagesize:2K, oobzie:64, ecctype:4bit
Nand(Hardware): 256 MiB
startcode select the uboot to load
the high RAM is :8080103c
startcode uboot boot count:-1
use the main slave_param area from flash, the RAM data is not OK!!!
Use the UbootB to load first
Use the UbootB to load success
U-Boot 2010.03 (R16C10 Mar 10 2016 - 23:50:04)
DRAM:256 MB
Boot From NAND flash
Chip Type is SD5116H
NAND:Special Nand id table Version 1.23
Nand ID: 0xC2 0xDA 0x90 0x95 0x06 0x00 0x00 0x00
now using default nand flash type, Block:128KB Page:2KB!
ECC Match pagesize:2K, oobzie:64, ecctype:4bit
Nand(Hardware): Block:128KB Page:2KB Chip:128MB*1 OOB:64B ECC:4bit
128 MiB
Using default environment
In: serial
Out: serial
Err: serial
::CRC:0xc2c2c50, Magic1:0x5a5a5a5a, Magic2:0xa5a5a5a5, count:0, Co
mmitedArea:0x1, Active:0x0, RunFlag:0x2
Start from main system(0x1)!
CRC:0xc2c2c50, Magic1:0x5a5a5a5a, Magic2:0xa5a5a5a5, count:1, CommitedArea:0x1,
Active:0x1, RunFlag:0x2
0x000000100000-0x000008000000 : "mtd=1"
UBI: attaching mtd1 to ubi0
UBI: empty MTD device detected
UBI: create volume table (copy #1)
UBI error: ubi_scan_get_free_peb: no eraseblocks found
UBI error: ubi_init: cannot attach mtd1
UBI error: ubi_init: UBI error: cannot initialize UBI, error -28
UBI init error -28
ERROR: failed to select 'ubifs' partition, please format it first!
hisilicon #
提示：加载mtd1失败，无法选择“ubifs”分区，请先格式化它！
求大神提供格式化“ubifs”分区的命令及救砖办法？
谢谢指导！！!
取下光纤，重新接上电源，耐心等待 30 分钟。 试试长按复位按键呢 keboy520 发表于 2020-2-5 19:05
试试长按复位按键呢
长按复位按键无效，mtd分区有问题了，加载mtd1失败，无法选择“ubifs”分区，提示格式化它！
试试长按复位按键呢 rocksoft 发表于 2020-2-9 01:21
试试长按复位按键呢
长按复位按键无效
页:
[1]