|
需要改蓝色文件内的数据
root@BrightBox:/etc # ls
[1;36mbftpd.conf[0m [1;32mglbcfg.manuf[0m [1;32minputrc[0m [1;36mresolv.conf[0m
[1;34mchatscripts[0m [1;
[0m [1;34ml7-protocols[0m [1;32mscriptd.conf[0m
[1;36mconfig[0m [1;32mglbcfg_ETH.save[0m [1;36mmtab[0m [1;32msecuretty[0m
[1;36mdnsmasq[0m [1;36mgroup[0m [1;36mpasswd[0m [1;32mservices[0m
[1;32methertypes[0m [1;36mhosts[0m [1;32mprofile[0m [1;32mshadow[0m
[1;32mfstab[0m [1;34mhotplug.d[0m [1;32mprotocols[0m [1;32mshells[0m
[1;32mfunctions.sh[0m [1;32mhotplug2.rules[0m [1;32mrandom-seed[0m [1;34msshd[0m
[1;34mgcom[0m [1;34minit.d[0m [1;32mrc.common[0m [1;36mudhcpd[0m
[1;32mglbcfg.dft[0m [1;32minittab[0m [1;34mrc.d[0m
root@BrightBox:/etc #
#username: user name for authentication (PPPoE, PPPoA)
#password: password for authentication (PPPoE, PPPoA)
#idletime: idle time (PPPoE, PPPoA)
#retrytime: connection retry time (PPPoE, PPPoA)
#keepalivetime: keepalive time (PPPoE, PPPoA)
#mtu: MTU
#connecttype: connection type, 0 is always, 1 is auto, 2 is manual (connected at start), 3 is manual (disconnected at start), 4 is manual (last state)
# Ethernet WAN, wanETH is for ethernet WAN, 1 instance
@wanETH
ifname=eth3
proto=4
vlan=1
ipassigned=1
ip4addr=0.0.0.0
ip4mask=0.0.0.0
ip4gateway=0.0.0.0
authprotocol=1
username=readytoconnect@fs
password=mistyview
idletime=0
retrytime=30
keepalivetime=60
mtu=1492
connecttype=0
# static_dns 0 (disable), 1 (enable: ignore those dynamic assigned entries)
static_dns=0
pri_dns=0.0.0.0
sec_dns=0.0.0.0
password_vis=0
|
|