ddr-160 发表于 2012-10-21 07:25:35

是波特率设错了,改成115200就OK了,但现在是这个样子,不知道怎么办了:


CFE version 1.0.37-102.9 for BCM96358 (32bit,SP,BE)
Build Date: Wed Jul 29 20:25:16 CST 2009 (kevin@BS5)
Copyright (C) 2000-2009 Broadcom Corporation.

Parallel flash device id 227a is not supported.

*** Board is not initialized properly ***

*** Upgrading NVRAM (version 8519744 to version 5) ***


*** Board is not initialized properly ***

Press:<enter> to use current value
      '-' to go previous parameter
      '.' to clear the current value
      'x' to exit this command
96358VW2         ------- 0
96358VW          ------- 1
96358GWVG      ------- 2
96358IVWG      ------- 3
96358SV          ------- 4
96358ADWG      ------- 5
Board Id (0-5)                  : 5

Number of MAC Addresses (1-32)    :107315212

Base MAC Address                  :01:02:00:30:00:00

PSI Size (1-64) KBytes            :2464

Main Thread Number           :1048832


Press:<enter> to use current value
      '-' to go previous parameter
      '.' to clear the current value
      'x' to exit this command
GPON Serial Number                :vw


Invalid GPON Serial Number;Try again!
GPON Serial Number                :96358ADWG


Invalid GPON Serial Number;Try again!
GPON Serial Number                :

longyo 发表于 2013-4-26 08:40:45


串口重新拔插一下
页: 1 [2]
查看完整版本: 请教TTL线刷DB120-B1问题!!