华为HG553 TTL 信息 求助
我一台华为HG553 刷了OPENWRT之后。只有电源灯亮。网卡不能获取地址。按住RESET30秒，指定网卡地址（192.168.1.X192.168.0.X)也没办法打开页面。现在只能用TTL读取下面信息。请大家帮忙看看Linux version 2.6.39.2 (buildslave@dd.das-iro.de) (gcc version 4.5.4 20110526 (p
rerelease) (Linaro GCC 4.5-2011.06-0) ) #1 Sun Aug 14 00:10:10 CEST 2011
Detected Broadcom 0x6358 CPU revision a1
CPU frequency is 300 MHz
64MB of RAM installed
registering 40 GPIOs
board_bcm963xx: Boot address 0xbe000000
board_bcm963xx: CFE version: 100.48.56-48.46
bootconsole enabled
CPU revision is: 0002a010 (Broadcom BMIPS4350)
board_bcm963xx: board name: HW553
Determined physical RAM map:
memory: 04000000 @ 00000000 (usable)
Initrd not found or empty - disabling initrd
Zone PFN ranges:
Normal 0x00000000 -> 0x00004000
Movable zone start PFN for each node
early_node_map active PFN ranges
0: 0x00000000 -> 0x00004000
Built 1 zonelists in Zone order, mobility grouping on.Total pages: 16256
Kernel command line:root=/dev/mtdblock2 rootfstype=squashfs,jffs2 noinitrd con
sole=ttyS0,115200
PID hash table entries: 256 (order: -2, 1024 bytes)
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Primary instruction cache 16kB, VIPT, 2-way, linesize 16 bytes.
Primary data cache 16kB, 2-way, VIPT, cache aliases, linesize 16 bytes
Memory: 61864k/65536k available (2199k kernel code, 3672k reserved, 449k data, 1
72k init, 0k highmem)
NR_IRQS:128
Calibrating delay loop... 299.26 BogoMIPS (lpj=598528)
pid_max: default: 32768 minimum: 301
Mount-cache hash table entries: 512
NET: Registered protocol family 16
registering PCI controller with io_map_base unset
registering PCI controller with io_map_base unset
bio: create slab <bio-0> at 0
pci 0000:00:01.0: BAR 0: assigned
pci 0000:00:01.0: BAR 0: set to (PCI address [0x3000
0000-0x30001fff])
pci 0000:01:1e.0: BAR 10: assigned
pci 0000:01:1e.0: BAR 7: assigned
pci 0000:01:1e.0: BAR 8: assigned
pci 0000:01:1e.0: CardBus bridge to
pci 0000:01:1e.0: bridge window
pci 0000:01:1e.0: bridge window
pci 0000:01:1e.0: bridge window
PCI: Enabling device 0000:01:1e.0 (0000 -> 0003)
Switching to clocksource MIPS
PCI: Enabling device 0000:00:01.0 (0000 -> 0002)
ssb: Sonics Silicon Backplane found on PCI device 0000:00:01.0
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 2048 (order: 2, 16384 bytes)
TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
TCP: Hash tables configured (established 2048 bind 2048)
TCP reno registered
UDP hash table entries: 256 (order: 0, 4096 bytes)
UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
NET: Registered protocol family 1
audit: initializing netlink socket (disabled)
type=2000 audit(0.284:1): initialized
squashfs: version 4.0 (2009/01/31) Phillip Lougher
JFFS2 version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006
Red Hat, Inc.
msgmni has been set to 120
io scheduler noop registered
io scheduler deadline registered (default)
bcm63xx_uart.0: ttyS0 at MMIO 0xfffe0100 (irq = 10) is a bcm63xx_uart
console enabled, bootconsole disabled
console enabled, bootconsole disabled
bcm963xx-flash bcm963xx-flash.0: 0x02000000 at 0x1e000000
bcm963xx: Found 1 x16 devices at 0x0 in 16-bit bank. Manufacturer ID 0x000001 Ch
ip ID 0x002101
Amd/Fujitsu Extended Query Table at 0x0040
Amd/Fujitsu Extended Query version 1.3.
number of CFI chips: 1
bcm963xx_flash: Read Signature value of CFE1CFE1
bcm963xx-flash bcm963xx-flash.0: CFE bootloader detected
bcm963xx_flash: CFE boot tag found with version 7 and board type HW553
bcm963xx_flash: Partition 0 is CFE offset 0 and length 20000
bcm963xx_flash: Partition 1 is kernel offset 4eb100 and length a2809
bcm963xx_flash: Partition 2 is nvram offset fe0000 and length 20000
bcm963xx_flash: Partition 2 is nvram offset fe0000 and length 20000
bcm963xx_flash: Spare partition is 58d909 offset and length a526f7
Creating 4 MTD partitions on "bcm963xx":
0x000000000000-0x000000020000 : "CFE"
0x0000004eb100-0x00000058d909 : "kernel"
mtd: partition "kernel" must either start or end on erase block boundary or be s
maller than an erase block -- forcing read-only
0x000000fe0000-0x000001000000 : "nvram"
0x000000020000-0x000001000000 : "linux"
bcm63xx_enet MII bus: probed
bcm63xx-wdt bcm63xx-wdt.0:started, timer margin: 30 sec
TCP westwood registered
NET: Registered protocol family 17
Bridge firewalling registered
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
jffs2: Too few erase blocks (1)
List of all partitions:
1f00 128 mtdblock0(driver?)
1f01 650 mtdblock1(driver?)
1f02 128 mtdblock2(driver?)
1f03 16256 mtdblock3(driver?)
No filesystem could mount root, tried:squashfs jffs2
Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(31,2)
帮帮忙啊，给我提示吧{:soso_e109:} 我也是啊,求助!!!
页:
[1]