终于把ST716V5 ADSL2+修改成ADSL模式(g.dmt)了。
本帖最后由 lu431015 于 2010-9-25 00:24 编辑方法如下:
{Administrator}=>?
Following commands are available :
help : Displays this help information
menu : Displays menu
? : Displays this help information
exit : Exits this shell.
.. : Exits group selection.
saveall : Saves current configuration.
ping : Send ICMP ECHO_REQUEST packets.
traceroute : Send ICMP/UDP packets to trace the ip path.
Following command groups are available :
firewall service autopvc connection cwmp
dhcp dns dsd dyndns eth
adsl atm config debug env
expr grp hostmgr ids igmp
interface ip ipqos label language
mbus memm mlp nat ppp
pptp script snmp sntp software
system systemlog tls upgrade upnp
user voice
{Administrator}=>adsl
{Administrator}=>config xdsltype=adsl2+
{Administrator}=>config xdsltype=adsl
{Administrator}=>saveall
但是感觉PING值下降了。
似乎没ADSL2+快 谁有详细配置指令说明? 我的也是716,,不知道LZ是怎么改的?能否做详细说明 telnet 192.168.1.254
{Administrator}=>adsl
{Administrator}=>config xdsltype=adsl
{Administrator}=>saveall
即可。
重启路由器 telnet 192.168.1.254
{Administrator}=>adsl
{Administrator}=>config xdsltype=adsl
{Administrator}=>saveall
即可。
重启路由器 已经改了,ping值降低了。速度也还好 感觉差不多啊。
PING值变化不大; 我的PING从48到35了 ADSL2+的端口,只要8M以下
可以工作在G.DMT模式
ISP维修人员有时碰到ADSL线路有些小毛病
把同步模式手动改到G.DMT求稳定
...但问题还在
所以楼主应该看看ADSL线路的同步参数是否正常
页:
[1]