[求助]全创1100-18不能拔号
我的全创1100-18猫终于刷成功了秒针的固件，却不能拔号，下面是系统信息，请各位分析一下01/01/1970 00:00:00> Ethernet Device 0 Detected
01/01/1970 00:00:00> ATM: Detected
01/01/1970 00:00:00> ATM: Setting up vcc0, VPI=0, VCI=35
01/01/1970 00:00:00> Initialized Dynamic NAPT.
01/01/1970 00:00:00> Verify Firmware OK
01/01/1970 00:00:00> CfgMgr: ';Shtm.dlz'; module loaded.
01/01/1970 00:00:06> CfgMgr: ';Washer.dlz'; module loaded.
01/01/1970 00:00:17> ATM Connected
01/01/1970 00:00:17> ATM layer is up, cell delineation achieved
01/01/1970 00:00:17> ADSL connected
01/01/1970 00:00:17> Modulation: G.dmt
01/01/1970 00:00:17> Annex Mode: ANNEX_A
01/01/1970 00:00:17> Max Tx Power: -38dBm/Hz
01/01/1970 00:00:17> CO Vendor: TEXAS_INSTRUMENTS
01/01/1970 00:00:17> d/s SNR: 6.6dB, u/s SNR: 14.0dB
01/01/1970 00:00:17> d/s Attenuation: 35.6dB, u/s Attenuation: 31.5dB
01/01/1970 00:00:17> d/s Data Rate: 1024kbps, u/s Data Rate: 352kbps
01/01/1970 00:00:17> d/s Latency: FAST, u/s Latency: FAST
01/01/1970 00:00:17> d/s total bit capacity: 614bits, used: 264bits
01/01/1970 00:00:17> u/s total bit capacity: 113bits, used: 113bits
01/01/1970 00:00:17> ATM Tx Error Count: 0, Rx Error Count: 0
01/01/1970 00:00:17> PPP1 PPPoE PADI Sent
01/01/1970 00:00:29> ATM Disconnected
01/01/1970 00:00:29> ADSL disconnected
01/01/1970 00:00:29> PPP1 PPPoE Session is terminated.
01/01/1970 00:00:31> ADSL detected
01/01/1970 00:00:38> ATM Connected
01/01/1970 00:00:38> ATM layer is up, cell delineation achieved
01/01/1970 00:00:38> ADSL connected
01/01/1970 00:00:38> Modulation: G.dmt
01/01/1970 00:00:38> Annex Mode: ANNEX_A
01/01/1970 00:00:38> Max Tx Power: -38dBm/Hz
01/01/1970 00:00:38> CO Vendor: TEXAS_INSTRUMENTS
01/01/1970 00:00:38> d/s SNR: 21.6dB, u/s SNR: 13.0dB
01/01/1970 00:00:38> d/s Attenuation: 35.7dB, u/s Attenuation: 31.5dB
01/01/1970 00:00:38> d/s Data Rate: 1024kbps, u/s Data Rate: 384kbps
01/01/1970 00:00:38> d/s Latency: FAST, u/s Latency: FAST
01/01/1970 00:00:38> d/s total bit capacity: 659bits, used: 264bits
01/01/1970 00:00:38> u/s total bit capacity: 121bits, used: 121bits
01/01/1970 00:00:38> ATM Tx Error Count: 0, Rx Error Count: 0
01/01/1970 00:00:41> PPP1 PPPoE PADI Sent
01/01/1970 00:00:41> PPP1 PPPoE PADR Sent, Service-Name: AC-Name:M-YL-BOBAI-B-5200G-01
01/01/1970 00:00:41> PPP1 PPPoE PADS ReceivedService-Name: AC-Name:M-YL-BOBAI-B-5200G-01
01/01/1970 00:00:41> PPP1 PPPoE Session is established.
01/01/1970 00:00:45> PPP PAP Authentication failed
01/01/1970 00:00:45> PPP Invalid Username or Password
01/01/1970 00:00:45> PPP1 Session is down.
我遇到同样的问题，你解决没？
页:
[1]