合勤642 Adsl Modem的端口映射设置『 ADSL技术交流区』(历史记录)

pcdoctor 发表于 2004-5-3 22:24:13

合勤642 Adsl Modem的端口映射设置

LBHIDDENLBHIDDEN[这个贴子最后由pcdoctor在 2004/05/03 10:46pm 第 1 次编辑]

方法:在运行里或MSDOS窗口里输入telnet 192.168.1.1
输入密码（出厂的缺省值为1234）后即可进入ZyXEL系统，会看到如下图所示的主菜单
Copyright (c) 1994 - 2000 ZyXEL Communications Corp.
                        Prestige 642-s Main Menu
Getting Started                   Advanced Management
   1. General Setup                   21. Filter Set Configuration
   3. Ethernet Setup                   22. SNMP Configuration
   4. Internet Access Setup             23. System Password
                                          24. System Maintenance
                                          25. IP Routing Policy Setup
Advanced Applications
   11. Remote Node Setup
   12. Static Routing Setup
   15. SUA Server Setup             99. Exit
进入Menu 11.1 - Remote Node Profile
Rem Node Name= ChangeMe          Route= IP
Active= Yes                      Bridge= No
Encapsulation= PPPoE             Edit PPP Options= No
Multiplexing= LLC-based          Rem IP Addr= 0.0.0.0
Incoming:                         Edit IP/IPX/Bridge= No
   Rem Login=
   Rem Password= ********
Outgoing:                         Session Options:
   My Login= ********@163.gd          Edit Filter Sets= No
   My Password= ********             PPPoE Idle Timeout(sec)= 0
   Authen= CHAP/PAP                   PPPoE Service Name=
                                       Schedule Sets=

               Press ENTER to Confirm or ESC to Cancel:
注意在 Edit Filter Sets= No 空格键改为YES后，进入以下菜单：

         Menu 11.5 - Remote Node Filter
   Input Filter Sets:
      protocol filters=6
         device filters=
   Output Filter Sets:
      protocol filters=
         device filters=
   Call Filter Sets:
      protocol filters=
         device filters=

      Enter here to CONFIRM or ESC to CANCEL:

将出现的 6 空格键去掉后回车存盘返回后 Edit Filter Sets= No 不要管它，回车存盘后设置15

                  Menu 15 - SUA Server Setup

            Port #       IPAddress
            ------    ---------------
         1.Default    192.168.1.XXX(将所有端口映射到这台机上)
         2. 0       0.0.0.0
         3. 0       0.0.0.0
         4. 0       0.0.0.0
         5. 0       0.0.0.0
         6. 0       0.0.0.0
         7. 0       0.0.0.0
         8. 0       0.0.0.0
            Press ENTER to Confirm or ESC to Cancel:

whket 发表于 2004-5-4 10:39:38