xljh888 发表于 2005-11-1 09:02:10

[原创]我的DB 108-B开路由无法上网，拨号就能上

01/01/1970 00:00:17> PPP1 PPPoE PADI Sent
01/01/1970 00:00:17> ATM Tx Error Count: 0, Rx Error Count: 0
01/01/1970 00:00:17> u/s total bit capacity: 201bits, used: 201bits
01/01/1970 00:00:17> d/s total bit capacity: 1207bits, used: 560bits
01/01/1970 00:00:17> d/s Latency: INTERLEAVED, u/s Latency: INTERLEAVED
01/01/1970 00:00:17> d/s Data Rate: 2048kbps, u/s Data Rate: 640kbps
01/01/1970 00:00:17> d/s Attenuation: 54.4dB, u/s Attenuation: 27.5dB
01/01/1970 00:00:17> d/s SNR: 18.8dB, u/s SNR: 23.0dB
01/01/1970 00:00:17> CO Vendor: TEXAS_INSTRUMENTS
01/01/1970 00:00:17> Max Tx Power: -38dBm/Hz
01/01/1970 00:00:17> Annex Mode: ANNEX_A
01/01/1970 00:00:17> Modulation: G.dmt
01/01/1970 00:00:17> ADSL connected
01/01/1970 00:00:17> ATM layer is up, cell delineation achieved
01/01/1970 00:00:17> ATM Connected
01/01/1970 00:00:06> CfgMgr: ';Washer.dlz'; module loaded.
01/01/1970 00:00:00> CfgMgr: ';Shtm.dlz'; module loaded.
01/01/1970 00:00:00> Verify Firmware OK
01/01/1970 00:00:00> Initialized Dynamic NAPT.
01/01/1970 00:00:00> ATM: Setting up vcc0, VPI=8, VCI=35
01/01/1970 00:00:00> ATM: Detected
01/01/1970 00:00:00> Ethernet Device 0 Detected

yiping 发表于 2005-11-1 09:38:19

[原创]我的DB 108-B开路由无法上网，拨号就能上

你们当地可能设置了MAC地址绑定，你开路由，然后在MAC地址欺骗那里把你的电脑的网卡MAC输进去就是

xljh888 发表于 2005-11-1 10:41:58

[原创]我的DB 108-B开路由无法上网，拨号就能上

我打开了MAC地址欺骗更本没用

yiping 发表于 2005-11-1 11:23:40

[原创]我的DB 108-B开路由无法上网，拨号就能上

MAC地址欺骗功能应该是可以的。你自己电脑的MAC地址是多少？你需要正确的输到电脑里面才行。

xljh888 发表于 2005-11-2 19:23:44

[原创]我的DB 108-B开路由无法上网，拨号就能上

01/01/1970 00:00:00> Ethernet Device 0 Detected
01/01/1970 00:00:00> ATM: Detected
01/01/1970 00:00:00> ATM: Setting up vcc0, VPI=8, VCI=35
01/01/1970 00:00:00> Initialized Dynamic NAPT.
01/01/1970 00:00:00> Verify Firmware OK
01/01/1970 00:00:00> CfgMgr: ';Shtm.dlz'; module loaded.
01/01/1970 00:00:06> CfgMgr: ';Washer.dlz'; module loaded.
01/01/1970 00:00:17> ATM Connected
01/01/1970 00:00:17> ATM layer is up, cell delineation achieved
01/01/1970 00:00:17> ADSL connected
01/01/1970 00:00:17> Modulation: G.dmt
01/01/1970 00:00:17> Annex Mode: ANNEX_A
01/01/1970 00:00:17> Max Tx Power: -38dBm/Hz
01/01/1970 00:00:17> CO Vendor: TEXAS_INSTRUMENTS
01/01/1970 00:00:17> d/s SNR: 18.8dB, u/s SNR: 23.0dB
01/01/1970 00:00:17> d/s Attenuation: 54.4dB, u/s Attenuation: 27.5dB
01/01/1970 00:00:17> d/s Data Rate: 2048kbps, u/s Data Rate: 640kbps
01/01/1970 00:00:17> d/s Latency: INTERLEAVED, u/s Latency: INTERLEAVED
01/01/1970 00:00:17> d/s total bit capacity: 1207bits, used: 560bits
01/01/1970 00:00:17> u/s total bit capacity: 201bits, used: 201bits
01/01/1970 00:00:17> ATM Tx Error Count: 0, Rx Error Count: 0
01/01/1970 00:00:17> PPP1 PPPoE PADI Sent
有人说是没或得IP地址才上不去的，怎样解决

barbaraincn 发表于 2005-11-4 11:43:44

[原创]我的DB 108-B开路由无法上网，拨号就能上

好象内置拨号根本就没动，贴上我的：
01/01/1970 00:00:00> Ethernet Device 0 Detected
01/01/1970 00:00:00> ATM: Detected
01/01/1970 00:00:00> ATM: Setting up vcc0, VPI=0, VCI=35
01/01/1970 00:00:00> ATM: Setting up vcc1, VPI=0, VCI=100
01/01/1970 00:00:00> ATM: Setting up vcc2, VPI=14, VCI=24
01/01/1970 00:00:00> ATM: Setting up vcc3, VPI=0, VCI=50
01/01/1970 00:00:00> Initialized Dynamic NAPT.
01/01/1970 00:00:00> Verify Firmware OK
01/01/1970 00:00:00> CfgMgr: ';Shtm.dlz'; module loaded.
01/01/1970 00:00:06> CfgMgr: ';Washer.dlz'; module loaded.
01/01/1970 00:00:18> Send UPnP Disconnected
01/01/1970 00:00:20> ATM Connected
01/01/1970 00:00:20> ATM layer is up, cell delineation achieved
01/01/1970 00:00:20> ADSL connected
01/01/1970 00:00:20> Modulation: G.dmt
01/01/1970 00:00:20> Annex Mode: ANNEX_A
01/01/1970 00:00:20> Max Tx Power: -38dBm/Hz
01/01/1970 00:00:20> CO Vendor: GLOBESPAN
01/01/1970 00:00:20> d/s SNR: 21.2dB, u/s SNR: 14.0dB
01/01/1970 00:00:20> d/s Attenuation: 13.9dB, u/s Attenuation: 9.0dB
01/01/1970 00:00:20> d/s Data Rate: 2048kbps, u/s Data Rate: 512kbps
01/01/1970 00:00:20> d/s Latency: FAST, u/s Latency: FAST
01/01/1970 00:00:20> d/s total bit capacity: 1517bits, used: 520bits
01/01/1970 00:00:20> u/s total bit capacity: 136bits, used: 136bits
01/01/1970 00:00:20> ATM Tx Error Count: 0, Rx Error Count: 0
01/01/1970 00:00:20> PPP1 PPPoE PADI Sent
01/01/1970 00:00:24> PPP1 PPPoE PADR Sent, Service-Name: AC-Name:zz_lh_8850
01/01/1970 00:00:24> PPP1 PPPoE PADS ReceivedService-Name: AC-Name:zz_lh_8850
01/01/1970 00:00:24> PPP1 PPPoE Session is established.
01/01/1970 00:00:24> PPP1 PAP Authentication success
01/01/1970 00:00:24> PPP1: PPP IP address is 220.161.42.176
01/01/1970 00:00:24> PPP1: PPP Gateway IP address is 172.16.0.1
01/01/1970 00:00:24> PPP1: DNS Primary IP address is 218.85.157.99
01/01/1970 00:00:24> PPP1: DNS Secondary IP address is 202.101.112.55
01/01/1970 00:00:24> NAT/NAPT Session Start: interface ppp1, WAN IP is 220.161.42.176
01/01/1970 00:00:24> No Static Session Information is defined.
01/01/1970 00:00:25> DNS: Add IP address 218.85.157.99 (Auto discovered)
01/01/1970 00:00:25> DNS: Add IP address 202.101.112.55 (Auto discovered)
01/01/1970 00:00:25> PPP1 Session is up.
11/04/2005 05:36:51> Received time from Time Server 129.6.15.29
11/04/2005 05:36:51> Send UPnP Connected
11/04/2005 05:36:58> UPnP Action:AddPortMapping State:Success. TCP-port:10172 Opened!
11/04/2005 05:36:58> UPnP Action:AddPortMapping State:Success. UDP-port:10172 Opened!
页: [1]
查看完整版本: [原创]我的DB 108-B开路由无法上网，拨号就能上